 Hotpoint washing machines and washer dryers come equipped with Super Silent operation, a Quick Wash and deliver 'A' rated wash performance, even at 40°C. Hotpoint washing machines have considered every detail, even the hinges have been designed to make hanging the panels easier and speed up the fitting process.
'A' Wash at 40°C
The best 'A' wash performance at 40 °C, the most commonly used wash temperature.
Super Silent
Hotpoint Washing Machines and Washer Dryers have a specialised induction motor which dramatically reduces noise levels during the wash cycle to as low as46dB(A}
Drying Levels
At the turn of a dial you can choose the drying level to suit your load - Iron Dry, ready for ironing; Dry, ready to wear; and Extra Dry ideal for towels.
Quick Wash
Keeping up with the pace of modern life, Hotpoint's Quick Wash means a small load washes in minutes, saving you the time of waiting for a full wash to finish.
Wash and Dry
Hotpoint resourceful washer dryer washes and dries 4kg in one uninterrupted cycle, allowing you to wash and dry your clothes in one go.
Platinum Woolmark
Endorsed by Woolmark*, the Hand Wash Wool programme on Hotpoint washing machines takes the ultimate care of your woollens.
HOTPOINT WASHING MACHINES INSTALLATION
Hotpoint Washing Machines are height adjustable from 820mm to 835mm. A height increase kit is incorporated into the washing machines to increase this to 870mm. In addition a top filler piece will allow the washing machines to be fitted up to 900mm.
Four way hinges fitted to Hotpoint washing machines allow maximum adjustment to the door to ensure perfect alignment.
Drainage can be achieved either through a down pipe between 60cm and 100cm high or alternatively through a waste spigot under the sink trap.
• Fit the plastic filler piece [located in the polystyrene packaging at the top of washing machines] to the top front of the appliance.
• Measure the height of the aperture into which washing machines are to be located [usually 870mm).
• Adjust all four feet accordingly and level appliance with a spirit level.
• Connect the hot and cold inlet pipes to the rear of the appliance. [Some appliances are cold
fill only.)
• Move washing machines in front of aperture [position to one side] feed inlet and outlet pipes through side of cabinetry, left or right to facilitate appropriate installation. Connect to water supply and water outlet.
• Connect electrical plug to a suitable socket.
• Turn washing machines on and select a wash programme, allow machine to partially fill. Advance programme to spin and allow machine to empty.
• Check all connections for leaks.
• Push washing machines back inside aperture; make final adjustment to feet to ensure the final sighting is level.
• Mount the hinge supports onto the front of the appliance.
• Mount the magnetic plate on the opposite side to the top hinge.
• If door is predrilled, fit hinges, magnet and door buffer to the door [if not predrilled use the template and drill two holes on either side of the door).
• Fix the hinges, magnet and buffer to the door. Offer door to appliance and secure hinges.
• Ensure the door in the closed position is in plumb vertically in line with the surrounding cabinetry and adjust the washing machines feet accordingly.
|
